Wheel Dresser
specifications >
Wheel Dresser
instructions >
Wheel Dresser
attachments >
Fluidmotion Wheel Dressers
Dressing complex forms on cylindrical, surface, tool and cutter grinder wheels with guaranteed .0001 accuracy is easy with a micrometer fed J&S Fluidmotion Wheel Dresser. You won’t believe how simple it is, even for a beginner, to dress two angles tangent to a radius in one continuous motion – with only one setting. Better still, the diamond will automatically return to the center position after dressing the angles.

This is not new, Fluidmotion dressers have been consistently performing in this manner since J&S introduced the first model over 60 years ago. Quality proven and tested, many of these original, American made units are still performing with outstanding accuracy after being rebuilt at our facility.





A Portion of the Forms Attainable with Fluidmotion Dressers

Wheel Dresser Features

ELIMINATE ELABORATE SETUPS
No need to pre-set diamond or use any other tool except a micrometer and a simple hex wrench. No Gage Block–Master Gage setting–Jo Block–Parallel Bar–Surface Plate–Height Gage– Dial indicator. No movement of dovetails necessary to form angles. The angle is dressed by continuing to push handle in both directions after radius is formed. No need to use Gibs & V-Ways other than positioning surfaces.

ACCURATE–RAPID, REPEAT FORM-DRESSING
Fluidmotion generates clean, precise wheel profiles entirely free of chatter marks. Without FLUIDMOTION a perfect blend of angles and radius is improbable.

PRECISE SHARP CONTOURS
Concave or convex, at a full 180 degrees, are obtained consistently with 0.0001” accuracy guaranteed.

CONVEX RANGE
Zero to 3 inches.
If the models desired in this catalog do not answer your particular grinding requirements, special dressing equipment can be furnished to your specifications to dress wheels up to 42” in diameter.

CONCAVE RANGE
1/32” to 3 1/2 inches.

PRECISION
Hold Intersecting angles –12 to 15 seconds. This is accomplished by operating upright and handle.

SET UP TIME
Setting up two angles requires 10 seconds. Setting two angles and radius requires less than 3 minutes.

MOST DURABLE DRESSER AVAILABLE
Manufactured in the U.S.A. from hardened, ground and lapped alloy steels. No wear surfaces. Swivels on sealed bearings.


 
   

home | about centers | live centers | dead centers
wheel dressers | contact us

All information © 2001 J&S Tool Livingston, New Jersey.
For more information contact J&S Tool at info@jstool.com